Networking
Updating Network Settings via USB
If you are unable to set the network settings via CUBE's techmenu, you can follow these steps to configure the network using a USB drive. Needed Tools USB drive Note that this drive should be formatted as FAT, with Master Boot Record (MBR) as the ...
Can the CUBE connect to a Wifi network?
For connecting a CUBE to a wifi connection, we would recommend that they use an ethernet bridge for this, which is much more reliable than a USB wifi dongle. Some examples of these are: Vonets VAR11N - http://en.vonets.es/products/VAR11N/ Vonets ...
Network Diagnostics via USB
To view the current network diagnostics from a CUBE: Unzip the attached USB Diagnostic Tools folder Copy "Manifest.xls" and "netdiag.txt" onto the root of a USB drive Insert USB drive into CUBE Wait about 1-2 minutes Remove USB drive, and insert ...
Network Troubleshooting via techmenu
If the CUBE is physically connected properly, but is not showing connecting in the Cubemc.net interface, you can connect a VGA monitor and USB keyboard to the CUBE to troubleshoot. You can also use this method to manually set an IP address, gateway, ...
CUBE IT Fact Sheet
The CUBE appears no different than a user accessing a web page The CUBE only makes outbound network requests, checking periodically for programming and firmware updates. Virus- and malware-proof No apps other than CUBE firmware are executable in the ...
Network and Security Overview
Overview • CUBE firmware is encrypted on the storage card. • Upon activation, each card is uniquely locked to the particular hardware unit, and cannot be used in other hardware. • Transmission of firmware updates via the internet is encrypted. • ...