Adjusting the volume using a USB keyboard
Setting Master Output Volume
The master volume of audio playback can be changed by temporarily plugging in a standard USB keyboard, and using the top two rows of keys (1 through 0, and Q through P).
The row of keys 1 through 0 controls the Channel 1 (Left) master volume, while the row of keys Q through P controls the Channel 2 (Right) master volume.
Pressing the same key multiple times successively will toggle the volume between the 1st press and 2nd press levels. The table below describes the available volume levels.
Key for Channel 1 | Key for Channel 2 | Volume % (1st press) | Volume % (2nd press) |
---|
1 | q | 10 | 5 |
2 | w | 20 | 15 |
3 | e | 30 | 25 |
4 | r | 40 | 35 |
5 | t | 50 | 45 |
6 | y | 60 | 55 |
7 | u | 70 | 65 |
8 | i | 80 | 75 |
9 | o | 90 | 85 |
0 | p | 100 | 95 |
Related Articles
Network Diagnostics via USB
To view the current network diagnostics from a CUBE: Unzip the attached USB Diagnostic Tools folder Copy "Manifest.xls" and "netdiag.txt" onto the root of a USB drive Insert USB drive into CUBE Wait about 1-2 minutes Remove USB drive, and insert ...
How do I load a CUBE via USB?
How do I load content locally to the CUBE via USB drive? MOH only To use the CUBE as a USB-loaded device for MOH, follow these steps: Format a USB drive as Fat32 (or delete all existing files and folders from the drive) Copy your audio files to the ...
Using the WebUI app
WebUI is an app that is installed on the CUBE to allow local control of the CUBE for skipping tracks, blocking tracks and artists, and changing "channels" (based on the channels you make available to the location) Accessing the App The WebUI app can ...
Set a Static IP address via techmenu
Setting a static IP address via techmenu To set a static IP address on the CUBE using the techmenu, follow these steps: Connect a VGA screen to the VGA connection, and attach a USB keyboard to any USB port. Once you have a screen and keyboard ...
Network Troubleshooting via techmenu
If the CUBE is physically connected properly, but is not showing connecting in the Cubemc.net interface, you can connect a VGA monitor and USB keyboard to the CUBE to troubleshoot. You can also use this method to manually set an IP address, gateway, ...